Real Time 5VDC 750mAh Judicial Wristband GPS Tracking Watch

4G GPS Real-Time Tracking Bracelet with APP Anti Dismantling Watch Judicial Wristband

1.GPS Judicial Wristband Product introduction

Smart judicial supervision positioning wristband, also known as Beidou / GPS anti dismantle electronic bracelet,Using Beidou /GPS positioning combined with 4G full Netcom (2G / 3G / 4G) network, it has real-time positioning and data transmission, physical tamper resistance, health management function,instant messaging function, SOS emergency call,watchband disconnection alarm, Cross-border alarm and other functions.
The wristband adopts electronic pulse anti-disassemble stainless steel strap, which is certified by ROHS; strong tensile strength,and the torque is not less than 350N. Each product has an independent identification IMEI number. When the data is uploaded to the background, it can complete automatic identification, trajectory tracking, legal identity, non-disturbance and automatic investigation. It is widely used in attendance of executives outside the prison, track special groups outside the prison, automatic access management, etc.

2. GPS Judicial Wristband Product functions

• Beidou / GPS / WIFI / LBS multiple precise positioning modes
• SMS message receiving
• Two way phone call.
• Mechanical anti-disassemble.
• IP68 waterproof and dustproof
• Low power consumption, long standby time.
• History track query.
• SOS emergency dial alarm.
• Geo fence (No entry/exit) alarm.
• Key area alarm.
• Low power,watch band disconnect, shedding alarm

4G GPS Real-Time Tracking Bracelet with APP Anti Dismantling Watch Judicial Wristband

3. GPS Judicial Wristband Product parameters

4. GPS Judicial Wristband Instructions

1. SIM card installation

Open the sim card slot cover with the screwdriver, push the sim card into the sim card slot completely(the notch is upward, the chip is outward),then install the slot cover with the screws.You can take out the sim card with the Pin.(Note: The card is NANO card).

2.Strap installation

The user can adjust the length of the strap according to the size of the wrist. After the 10 adjust the strap, tight up the metal buckle with a special-shaped screw according to the position of the upper and lower buckle holes, and then close the plastic cover plate on the metal buckle.

3.Turn on/off

Press and hold the [Function key] for about 3 seconds until the boot bell and the boot interface (as shown in the figure) appear.This device cannot be manually shut down on the device end. If you need to shut down, you need to send a command through the system platform to turn off. Note: e The d wristband will y automatically n turn n on n when charging.